Alaxala AX6300S Series Instruction Manual page 47

Name Type
ACC LED: Green
RESET Switch
(non-locking)
ACH Switch
(non-locking)
ACTIVE LED: Green
SYSTEM1 LED: Green,
orange, or red
SYSTEM2 LED: Green,
orange, or red
LINK LED: Green or
yellow
T/R LED: Green
#1: A management and switching unit can be turned off by the Inactivate operation
from the system operation panel or by entering a command from the operation
terminal.
#2: The switch is recessed from the surface of the front panel. Use a screwdriver
with a small head to press it.
#3: If you press the switch for one second or less, the Switch might not be reset.
#4: After a restart, a login password and an administrator password are no longer
required. Be especially careful if you restart the unit with this method.
#5: The system can be switched only if you press the ACH switch on the
management and switching unit of the active system.
#6: Cable disconnection is also included.
#7: You can stop operation by entering a command.
Status
Indicates the memory
card status.
Used to reset the Switch
#2
manually.
Used to switch the
system of the
management and
#2 #5
switching unit.
Indicates whether the
management and
switching unit is the
active system or the
standby system.
Indicates the Switch
status.
This LED is not supported and is always off.
Indicates the operation
status of the
MANAGEMENT port.
When pressing a switch, do not use anything with a fragile tip, or
anything that might become caught in the Switch, such as a pin or
paper clip. Doing so could result in fire or electric shock.
1. Components Overview
Description
Green: The memory card is being
accessed. (Do not remove the memory
card.)
Off: The memory card is in idle mode.
(A memory card can be plugged in or
removed.)
Press one second: Use this method
when a Switch failure has occurred.
Press five seconds: Use this method
when you have forgotten the
#4
password.
When the management and switching
unit is duplicated, use this switch to
switch between the active system and
the standby system.
Green: Indicates the active system.
Off: Indicates the standby system.
Green: Operation is possible.
Orange: A partial Switch failure was
detected.
Red: A Switch failure was detected.
Green: A link is established.
Lit in yellow: A failure has been
detected.
Off: A link failure occurred
#7
operation has stopped.
Green: A packet is being sent or
received.
Off: No packets are being sent or
received.
#3
#6
or
23