Alaxala AX6300S Series Instruction Manual page 132

4. Installing a Switch
CAUTION
NOTE
Step 2
Clamp the power connector with the bracket.
Figure 4-23 Clamping the power connecter
(1) Bracket preventing disconnection of the power cable
NOTE
Step 3
Clamp the power cable by using the cable clamp.
Figure 4-24 Clamping the power cable
(1) Cable clamp
(2) Disconnecting the AC power cable
Reverse the steps described in (1) Connecting the AC power cable to disconnect
108
When using a Switch at 100 V AC, use the supplied power cable.
Using another cable could result in fire or electric shock. In addition,
do not use the supplied power cable with another switch. Doing so
could result in fire or electric shock.
When using a Switch in a 200 V AC environment, use only the
separately sold ALAXALA power cable, or a power cable that meets
ALAXALA specifications. Using another cable could result in fire or
electric shock. In addition, do not use the supplied power cable with
another switch. Doing so could result in fire or electric shock.
Before connecting or disconnecting a power cable, turn off the power
to the device to be installed or removed.
For the specifications defined by ALAXALA for power cables, see
2.4.2 Power supply facility for 200 V AC.
If the bracket is removed, do not perform this step.