Alaxala AX6300S Series Instruction Manual page 52

1. Components Overview
Name
LINK/TR
#1: A network interface unit can be turned off by the Inactivate operation from the
system operation panel or by entering a command from the operation terminal.
#2: If no system recovery is set, the network interface unit is turned off in the
following situations:
When a failure occurred in the network interface unit (the STATUS LED turns
red, and then it turns off).
When a failure occurred in a management and switching unit (when the
management and switching unit is not duplicated).
#3: When the STATUS LED is green.
#4: Cable disconnection is also included.
#5: Operation of an Ethernet port can be stopped by entering a command from the
operation terminal.
#6: Always turns off if the interface port LED is set to off. When an operation key on
the system operation panel is used, the LED lights up, and the operating status can
be checked. If no keys are used for 60 seconds, the LED turns off again.
NOTE
(3) NH1G-24S
The NH1G-24S is a network interface unit with the following hardware specification:
Ethernet port (1000BASE-X): 24 ports
NOTE
Front view
The front view is shown below.
For information about LEDs, see Table 1-15 LED indications.
28
Type Status
LED: Green or Indicates the
Orange operating status of
the Ethernet port.
If no system recovery is set and a failure occurs in a Switch, the
Switch can stay stopped without recovering the failed part.
This function is supported by software version 10.3 and later.
For information about the SFP transceivers supported by the Switch,
see 1.7.1 SFP.
Description
Indicates the operating status of the
#6
Ethernet port.
#6
Green: A link is established.
Blinking green: A frame is being sent
or received.
Orange: A failure has been detected.
Off: A link failure occurred
operation has stopped.
#3 #4
or
#3 #5