Alaxala AX6300S Series Instruction Manual page 101

Port Transceiver
SFP-BX4D
10GBASE-R XFP-SR
port
XFP-LR
XFP-ER
XFP-ZR
#2
AUX port --
CONSOLE --
port
MANAGEMEN --
T port
#1: Some kinds of multimode fiber optic might increase the BER (bit error rate)
when used with 1000BASE-LX. In this case, proper communication can be
established by using the mode-conditioning patch code.
#2: In the MSU-1A and MSU-1B, the AUX port is supported by software version
10.3 and later.
NOTE
NOTE
3. Preparation of Interface Cables and Terminals
Interface
1000BASE-BX4
0-D
10GBASE-SR Multimode fiber optic cable
(core/cladding diameter = 50
μm/125 μm)
Multimode fiber optic cable
(core/cladding diameter = 62.5
μm/125 μm)
10GBASE-LR Single-mode fiber optic cable
(core/cladding diameter = 10
10GBASE-ER
μm/125 μm)
10GBASE-ZR
RS-232C straight-through
RS-232C
cable
RS-232C RS-232C crossover cable
10BASE-T UTP cable (Category 3 or
higher)
100BASE-TX UTP cable (Category 5 or
higher)
For details about the interface cables to be connected to the
10/100/1000BASE-T port, 1000BASE-X port, or 10GBASE-R port, see
3.2 Details about interface cables.
For details about the terminals and interface cables to be connected to
the AUX port, the CONSOLE port, and the MANAGEMENT port, see
3.3 Terminals and connection cables.
Cable Connector
LC duplex
connector
D-SUB 9-pin
connector
D-SUB 9-pin
connector
RJ-45
connector
77