Alaxala AX6300S Series Instruction Manual page 192

5. Adding and Replacing Optional Modules
NOTE
Step 5
Turn on the management and switching unit. (Execute the Activate operation.)
NOTE
NOTE
Step 6
Restore the operation information. The restoration procedure varies according to
the case. Perform the appropriate procedure.
6-1 Synchronize the operation information of the management and switching unit
with the active system (when a unit has been added or when only one of the units in
a dual configuration has been replaced).
1. Match the software version with the version used in the active system (use
the
2. Synchronize the configuration, user account, password, license key, and
other settings with the settings used in the active system (use the
synchronize
3. When an optional license has been installed, restart the management and
switching unit of the standby system in order to reflect the license key
information (use the
6-2 Restore the operation information of the management and switching unit (when
only one unit has been replaced in a non-dual configuration).
1. Restore the operation information from the file you have backed up (use the
restore
or an FTP server.
6-3 Restore the operation information of the management and switching unit (when
both units in a dual configuration have been replaced).
1. Turn off the management and switching unit in the standby system so that the
system is not switched during restoration of the operation information
(execute the
2. Restore the operation information from the file you have backed up (use the
restore
or an FTP server.
3. Turn on the management and switching unit in the standby system (execute
168
Use a screwdriver to tighten the screws. Make sure the screws are
firmly tightened.
For details about the Activate operation, see 11 Switch Management
in the Software Manual Configuration Guide Vol. 1.
Executing the Activate operation starts loading of the software. If the
following conditions exist, the SYSTEM1 LED of the management and
switching unit lights in orange when the software has been loaded.
When the software is version 11.0 or later
When the license keys of the active system and the standby
system do not match (when an optional license is set in a dual
configuration)
When the operation information is restored by the following step, the
SYSTEM1 LED turns off.
command).
ppupdate
command).
reload
command). To do this, use the backup file stored on a memory card
Inactivate
command). To do this, use the backup file stored on a memory card
command).
operation).