5. Adding and Replacing Optional Modules
Figure 5-19 Checking the STATUS LED
(1) STATUS LED
(2) Management and switching unit
Step 2
Turn off the management and switching unit if the power is being supplied (execute
the Inactivate operation).
NOTE
Step 3
Loosen the screws of the management and switching unit.
Figure 5-20 Removing a management and switching unit (1)
(1) Screws
CAUTION
162
For details about the Inactivate operation, see 11 Switch Management
in the Software Manual Configuration Guide Vol. 1.
Loosen the screws completely. If the screws are not loose enough, the
management and switching unit might be damaged when the levers
are opened.