Accessories - Alaxala AX6300S Series Instruction Manual

1. Components Overview
Table 1-4 Installation locations of AC power supply units
Power supply Power
redundancy supply
method redundanc
y
2+2 None
redundancy
Required
NOTE
When installing a DC power supply unit
When installing a DC power supply unit on a Switch, the power supply redundancy
method is 1+1 redundancy.
One basic power supply unit and one power supply unit for redundancy are
required.
For the installation locations of the power supply units, see the following table.
Table 1-5 Installation locations of DC power supply units
Power supply
redundancy
method
1+1
redundancy
NOTE
(4) LEDs and switches
LEDs and switches are located on each optional module.
For information about the LEDs and switches on the front of the Switch, see 1.4
Management and switching unit (MSU) and 1.5 Network interface unit (NIF).
For information about the LEDs on the rear of the Switch, see 1.2 Fan unit (FAN)
and 1.3 Power supply unit (PS).

1.1.3 Accessories

The items listed in Table 1-6 Switch accessories are shipped with the Switch when it
is shipped from the factory.
Table 1-6 Switch accessories
Num
ber
1
2
10
Basic
PS1
Y
Y
If you install a power supply unit in a location other than those above,
it will not operate properly.
Power supply
redundancy
None
Required
If you install a power supply unit in a location other than those above,
it will not operate properly.
Name
Before using an AX6300S series switch
Using the Switch Safely
Redundancy
PS2 PS3 PS4
Y N
Y Y
Basic Redundancy
PS1 PS2
Y
Y
Quan
tity
1
1
For expansion
PS5 PS6
N N N
Y N N
For expansion
PS3
N N
Y N
Remarks