Alaxala AX6300S Series Instruction Manual page 56

1. Components Overview
Front view
The front view is shown below.
For information about LEDs, see Table 1-17 LED indications.
Figure 1-28 Front view
(1) STATUS LED
(2) LINK LED
(3) T/R LED
(4) Ethernet port (10GBASE-R)
LED
Table 1-17 LED indications
Name
STATUS
LINK
T/R
#1: A network interface unit can be turned off by the Inactivate operation from the
system operation panel or by entering a command from the operation terminal.
#2: If no system recovery is set, the network interface unit is turned off in the
following situations:
When a failure occurred in the network interface unit (the STATUS LED turns
red, and then it turns off).
When a failure occurred in a management and switching unit (when the
management and switching unit is not duplicated).
#3: When the STATUS LED is green.
#4: Cable disconnection is also included.
#5: Operation of an Ethernet port can be stopped by entering a command from the
operation terminal.
#6: Always turns off if the interface port LED is set to off. When an operation key on
32
Type
LED: Green, Indicates the
orange, or red operating status of
the network
interface unit.
LED: Green or Indicates the
Orange operating status of
the Ethernet
#6
port.
LED: Green
Status
Green: Operation is possible.
Orange: A reset is in progress.
Blinking green: Startup is in progress.
Red: A failure has been detected.
Off: Power is off. (The network
interface unit can be replaced.)
Green: A link is established.
Orange: A failure has been detected.
Off: A link failure occurred
operation has stopped.
Blinking green: A frame is being sent
or received.
Off: No frames are being sent or
received.
Description
#1 #2
#3 #4
or
#3 #5