Alaxala AX6300S Series Instruction Manual page 57

the system operation panel is used, the LED lights up, and the operating status can
be checked. If no keys are used for 60 seconds, the LED turns off again.
NOTE
(6) NH10G-4RX
The NH10G-4RX is a network interface unit with the following hardware
specification:
Ethernet port (10GBASE-R): 4 ports
NOTE
Front view
The front view is shown below.
For information about LEDs, see Table 1-18 LED indications.
Figure 1-29 Front view
(1) STATUS LED
(2) LINK LED
(3) T/R LED
(4) Ethernet port (10GBASE-R)
LED
Table 1-18 LED indications
Name
STATUS
LINK
If no system recovery is set and a failure occurs in a Switch, the
Switch can stay stopped without recovering the failed part.
This function is supported by software version 10.3 and later.
For information about the XFP transceivers supported by the Switch,
see 1.7.2 XFP.
Type
LED: Green, Indicates the
orange, or red operating status of
the network
interface unit.
LED: Green or Indicates the
Orange operating status of
the Ethernet
#6
port.
1. Components Overview
Status
Green: Operation is possible.
Orange: A reset is in progress.
Blinking green: Startup is in progress.
Red: A failure has been detected.
Off: Power is off. (The network
interface unit can be replaced.)
Green: A link is established.
Orange: A failure has been detected.
Off: A link failure occurred
operation has stopped.
Description
#1 #2
#3 #4
or
#3 #5
33