Alaxala AX6300S Series Instruction Manual page 23

Do not use a TV or a radio near a Switch.
Placing a Switch near a TV or a radio could affect both devices. If you hear noise on
the TV or radio, do the following:
Place the Switch as far away as possible from the TV or radio.
Adjust the orientation of the TV or radio antenna.
Use separate outlets.
Do not place a Switch where it will be exposed to hydrogen sulfide or
salt.
Placing a Switch in an area where sulfides are present, such as a hot-springs area,
or in an area with salty-air, such as along a coast could shorten the life of the
Switch.
Use care when handling an air duster.
Use an air duster specially designed for cleaning optical connectors. Using another
type of air duster could cause the ferrule tip to become dirty.
Keep the nozzle or container of the air duster from coming into contact with the
ferrule tip. Contact could result in a malfunction.
Use care when handling an optical connector cleaner.
Always use a dedicated optical connector cleaner. If you use another type of cleaner,
the ferrule tip might become dirty.
Before cleaning, make sure that the tip of the optical connector cleaner is clean and
free of defects, such as lint, dirt, or other foreign substances. Using a cleaner with a
defective tip might damage the ferrule tip.
Do not apply excessive pressure when cleaning. Doing so might damage the ferrule
tip.
Rotate the optical connector cleaner (stick) clockwise only. Rotating the cleaner
alternately clockwise and counterclockwise might damage the ferrule tip.
Maintenance
Clean any dirty areas on the exterior of the switch with a clean, dry cloth, or a cloth
damp with (but not soaked with) water or a neutral detergent. Do not use volatile
organic solutions (such as benzene or paint thinner), chemicals, chemically treated
cloths, or pesticides because these substances might deform, discolor, or damage
the switch.
If the Switch will not be used for a long time
For safety reasons, unplug the power cable from the outlet if the Switch will not be
used for a long time. If you are using a DC power supply, set the circuit breaker of
the power supply facility to OFF.
Safety Information
Safety-15