Installing And Removing A Single-Guide Rail - Alaxala AX6300S Series Instruction Manual

5. Adding and Replacing Optional Modules
NOTE

5.6.3 Installing and removing a single-guide rail

Before installing a single-size network interface unit in a Switch, install a
single-guide rail in the tray.
Before installing a double-size network interface unit in a Switch, remove the
single-guide rail from the tray.
(1) Removing a single-guide rail
Step 1
Remove the four screws securing the tray.
Figure 5-49 Removing a tray (1)
(1) Screws
(2) Tray
186
If you install a network interface unit (NIF) while the Switch is on, the
NIF is turned on automatically when the NIF is installed.
Note, however, that if no power enable is set in the configuration, the
NIF is not turned on automatically. Set power enable, and then turn on
the power.
For details about the
power enable
of BSU/NIF in the Software Manual Configuration Guide Vol. 1.
Installing and removing a single-guide rail must be performed by a
trained technician or maintenance personnel.
If another person performs the above and mishandles the single-guide
rail, injury or damage could result.
command, see 12. Management