General Information - Sea-doo RX Shop Manual

INTRODUCTION
LIST OF ABBREVIATIONS USED
IN THIS MANUAL
AC Alternate Current
APS Air Pressure Sensor
ATS Air Temperature Sensor
Bombardier Utility and Diagnostic
B.U.D.S.
Software
CDI Capacitor Discharge Ignition
CPS Crankshaft Position Sensor
CSI Cooling System Indicator
DC Direct Current
DESS Digitally Encoded Security System
E.I.N. Engine Identification Number
ECU Electronic Control Unit
EPA Environmental Protection Agency (USA)
HP Horse Power
LED Light Emitting Diode
MAG Magneto
MPEM Multi-Purpose Electronic Module
MPH Mile Per Hour
MPI Multi Protocol Interface
N.A. Not Applicable
OPT Optional
P/N Part Number
PFD Personal Flotation Device
PSI Pound Per Square Inch
PTO Power Take Off
RAVE Rotax Adjustable Variable Exhaust
RFI Rotax Fuel Injection
RPM Revolution Per Minute
STD Standard
TPS Throttle Position Sensor
VDC Volt Direct Current
VCK Vehicle Communication Kit
VDC Volt Direct Current
VTS Variable Trim System
WTS Water Temperature Sensor

GENERAL INFORMATION

The use of RIGHT and LEFT indications in the text,
always refers to driving position (when sitting on
watercraft).
VIII
DESCRIPTION
1
F01L45B
1. Left (port)
2. Right (starboard)
The information and component/system descrip-
tions contained in this manual are correct at time
of publication. Bombardier Inc. however, main-
tains a policy of continuous improvement of its
products without imposing upon itself any obliga-
tion to install them on products previously manu-
factured.
Bombardier Inc. reserves the right at any time to
discontinue or change specifications, designs,
features, models or equipment without incurring
obligation.
This Shop Manual uses technical terms which
may be different from the ones of the Parts Cata-
logs.
When ordering parts always refer to the specif-
ic model Parts Catalogs.
ILLUSTRATIONS AND
PROCEDURES
The illustrations show the typical construction of
the different assemblies and, in all cases, may not
reproduce the full detail or exact shape of the parts
shown, however, they represent parts which have
the same or a similar function.
CAUTION: These watercraft are designed with
parts dimensioned in both the metric and the
imperial systems. When replacing fasteners,
make sure to use only those recommended by
Bombardier.
As many of the procedures in this manual are in-
terrelated, we suggest, that before undertaking
any task, you read and thoroughly understand the
entire section or subsection in which the proce-
dure is contained.
www.SeaDooManuals.net
2
SMR2000_036_00A2.FM