Sea-doo RX Shop Manual page 107

Make sure all locating dowels are in place.
1
F06D1PA
1. Dowel
All Engines
Crankcase Screws
Apply Molykote 111 below head of screws and
Loctite 518 on threads.
Torque crankcase screws to 12 N•m (9 lbf•ft) as
per following sequence. Repeat procedure, re-
tightening all screws to 27 N•m (20 lbf•ft).
As a final step, torque only the M10 x 73.5 bolts
to 40 N•m (30 lbf•ft) as per following sequence.
SMR2000-047_04_06A.FM
9
7
3
1
5
11
F07D09C
Starter Drive Bearing
To install bearing no. 23 of starter drive assembly,
use pusher (P/N 290 876 502) and handle (P/N 420
877 650).
1. Handle
2. Pusher
PTO Flywheel
Apply Loctite 243 (blue) on bolt no. 22.
Using the same tools as for disassembly proce-
dure, torque bolt no. 22 to 115 N•m (85 lbf•ft).
Apply Loctite 648 on mating surface of PTO fly-
wheel and coupler.
Apply Loctite 243 (blue) to Allen screws no. 21 of
coupler and torque to 23 N•m (17 lbf•ft).
www.SeaDooManuals.net
Section 04 ENGINE
Subsection 06 (BOTTOM END)
10
8
4
2
6
12
04-06-13