Sea-doo RX Shop Manual page 41

All Models
Close the water tap then stop the engine.
CAUTION: Always close the water tap before
stopping the engine.
Disconnect the garden hose.
CAUTION: Remove quick connect adapter after
flushing operation (if used).
Final Steps
Wipe up any residual water from the engine.
Remove spark plug cables and connect them on
the grounding device.
WARNING
Always use spark plug cable grounding de-
vice when removing spark plugs.
1. Grounding device
Remove both spark plugs and spray BOMBAR-
DIER LUBE lubricant into each cylinder.
Connect safety lanyard cap to the switch.
SMR2000-039_02_03A.FM
Subsection 03 (FLUSHING AND LUBRICATION)
Carburetor-Equipped Models
Fully depress the throttle lever then press the
start/stop button to crank the engine a few turns
to distribute the oil onto cylinder wall.
DI Models
NOTE: Proceeding in this order, no fuel will be in-
jected and no ignition will occur in the engine.
While engine is stopped, fully depress throttle le-
ver and HOLD for cranking.
Press the start/stop button to crank the engine a
few turns and distribute the lubricant onto cylinder
walls.
NOTE: A 1 second beep every second indicates the
drowned mode is active.
All Models
Apply anti-seize lubricant on spark plug threads
then reinstall them.
Always reconnect spark plug cables at the
same spark plugs where they come from. The
cable coming out the edge of the electrical
box must be connected to the MAG side spark
plug.
NOTE: Engine fogging should be done with BOM-
BARDIER LUBE lubricant whenever the water-
craft is to be stored for a few days or a long period.
CAUTION: Never leave rags or tools in the en-
gine compartment or in the bilge.
www.SeaDooManuals.net
Section 02 MAINTENANCE
WARNING
02-03-3