Sea-doo RX Shop Manual page 82

947 DI Engines
Use Snap-On Torx socket E12 and unscrew cylin-
der head screws no. 14 following the sequence
shown in the next illustration.
Remove cylinder head no. 2 and gasket no. 34.
Cylinder
NOTE: When removing cylinder, be careful that
connecting rods do not hit crankcase edge.
947 Carburetor-Equipped Engines
Remove studs no. 32. Take two head cover nuts.
Screw nuts onto stud. Lock both nuts together
and unscrew the stud. Repeat this operation for
the other studs.
NOTE: Studs must be removed prior cylinder block.
1
F06D2BA
1. Remove studs
Remove cylinder block no. 9.
SMR2000-046_04_05A.FM
F06D0ZA
1. Remove cylinder block
NOTE: To ease removal, a plastic tip hammer can
be used.
Remove cylinder base gasket no. 10.
947 DI Engines
Remove cylinders screws then cylinders no. 9.
All Engines
Piston
NOTE: All engines feature cageless piston pin
bearings.
Install rubber pad (P/N 290 877 032) to crankcase.
Secure with screws. Lower piston to be removed
until it sits on pad.
F06B06B
1. Rubber pad (P/N 290 877 032)
www.SeaDooManuals.net
Section 04 ENGINE
Subsection 05 (TOP END)
1
1
04-05-9