Sea-doo RX Shop Manual page 40

Section 02 MAINTENANCE
Subsection 03 (FLUSHING AND LUBRICATION)
1. Garden hose installed
2. Quick connector adaptor
Start the engine then immediately open the water
tap.
WARNING
Do not touch any electrical parts or jet pump
area when engine is running.
CAUTION: Never flush a hot engine. Always
start the engine before opening the water tap.
Open water tap immediately after engine is
started to prevent overheating.
Run the engine about 3 minutes at a fast idle around
3500 RPM.
Ensure water flows out of drain lines (engine crank-
case, engine cylinder and air compressor (DI mod-
els)) while flushing. Otherwise, clean the lines.
CAUTION: Never run engine longer than 5 min-
utes. Drive line seal has no cooling when wa-
tercraft is out of water.
Spray BOMBARDIER LUBE lubricant where
shown keeping engine at fast idle for approximate-
ly one minute.
02-03-2
Carburetor-Equipped Models
1. Air intake silencer
2. Spray BOMBARDIER LUBE here
DI Models
Spray, through hole of air intake silencer.
NOTE: An increase of engine RPM may be noticed
while spraying the lubricant in the air intake silencer.
1. Partially pull tube out of air box to inject BOMBARDIER LUBE
lubricant or equivalent. Push tube in when finished
Carburetor-Equipped Models
After fogging, close fuel valve to run engine out of
fuel while lubricating.
CAUTION: When engine begins to run irregu-
larly because of fuel starvation, immediately
close the water tap to stop water flow before
engine dies.
www.SeaDooManuals.net
SMR2000-039_02_03A.FM