Sea-doo RX Shop Manual page 68

Section 04 ENGINE
Subsection 03 (REMOVAL AND INSTALLATION)
Final Inspection
Check throttle cable condition and lubricate cable
with BOMBARDIER LUBE lubricant.
After its installation, properly adjust and bleed oil in-
jection pump as specified in OIL INJECTION PUMP
and adjust throttle cable as specified in ENGINE
MANAGEMENT.
Check hose condition and pressure test fuel sys-
tem, refer to FUEL CIRCUIT.
WARNING
Whenever doing any type of repair on water-
craft or if any components of the fuel system
are disconnected, a pressure test must be
done before starting engine.
Verify all electrical connections.
Run engine and ensure there is no leakage.
CAUTION: If watercraft is out of water, engine
must be cooled using the flush kit.
04-03-6
www.SeaDooManuals.net
SMR2000-044_04_03A.FM