Sea-doo RX Shop Manual page 182

Section 06 COOLING SYSTEM
Subsection 02 (CIRCUIT, COMPONENTS AND CARE)
Adjustment
The water flow regulator valve has been calibrated
at the factory and should not be modified.
NOTE: Water flow regulator valves ordered from
the parts channel are also calibrated. The valve cap
on the DI models is sealed and it is not adjustable.
If the maximum engine speed cannot be attained
or if the engine has poor performance, the water
flow regulator valve should be considered in the
troubleshooting of the problem.
Disassembly
Remove the cover of the valve by releasing the
spring.
WARNING
Firmly hold cover to valve base. The spring
inside the valve is applying a pressure against
the cover.
1
2
F01E1RA
1. Spring
2. Cover
06-02-8
Remove fitting from valve housing.
1
F01E1SA
TYPICAL
1. Fitting
Unscrew the tapered needle.
NOTE: Hold the valve to prevent it from turning.
1
F01E1TA
1. Tapered needle
www.SeaDooManuals.net
SMR2000-054_06_02A.FM