Sea-doo RX Shop Manual page 274

1. Flat side of pusher
2. Slider tab
Install O-ring no. 24 to cover. Apply Loctite 518 on
O-ring.
Install cover to jet pump housing making sure to
properly position filler plug on top side. Do not
torque yet, keep a small gap.
Insert a pencil or any other plastic tool in the hole
and push on the slider tab.
CAUTION: Do not use a metal tools for push the
tab. It is possible to damage the inner threads.
Hold tab and torque screws.
Remove pencil or tool to release locking mech-
anism.
Check if the mechanism worked properly. Push
tab with the pencil or tool, if there is a small play
the installation is corrected. If not, redo the proce-
dure.
Add oil.
Oil Fill
NOTE: It is highly recommended to perform a leak-
age test prior adding the oil. See PUMP PRESSUR-
IZATION in this subsection.
Place housing horizontally as in its operating posi-
tion so that filler plug is located on top. Remove
filler plug from cover. Pour SEA-DOO JET PUMP
SYNTHETIC OIL (P/N 293 600 011) in reservoir un-
til oil comes level with bottom of hole. Let oil drain
into housing and after a few minutes add more oil
until it is level with bottom of filler hole.
SMR2000_065_10_02A.FM
Section 10 PROPULSION SYSTEM
CAUTION: This is a synthetic oil. Do not mix
with mineral based oil. Do not mix oil brands.
NOTE: When filling reservoir, oil must be poured
into cover quite slowly to allow complete housing
fill.
F00J0JA
TYPICAL
1. Pour oil slowly until it is level with bottom of filler hole
Venturi
If needed, install new O-rings no. 8 around bailer
passages.
F00J0KA
1. O-rings
www.SeaDooManuals.net
Subsection 02 (JET PUMP)
1
1
10-02-17