Tools And Materials List; Thru-Hull Fitting Installation - Sea-doo RX Shop Manual

Inside
Wipe down the area with acetone on a cloth. Ap-
ply the same procedure as for outside repair when
laminating the alternating pieces of fiberglass ma-
terial. If a backing support was used, remove it
before starting the repair. After the area has hard-
ened, remove sharp edges of material from sur-
face. If required paint the surface.
SANDING
Outside
This surface will have to be prepared for applica-
tion of gelcoat. The size of the area will determine
the gelcoating procedure to be used. Refer to the
repair procedure for minor gelcoat fractures.
BUFFING AND WAXING
Refer to the buffing and waxing for Minor Gelcoat
Fractures.

TOOLS AND MATERIALS LIST

Tools
– safety glasses
– air mask
– white cloths
– sanding block
– putty knife
– plastic film
– stirring stick
– cover sheets (for Sea-Doo)
– scissors
– buffing pad
– heavy-duty polisher
– power sander
– paint brush
– plastic container (mixing)
– spray gun
– plastic squeegee
SMR2000-071_12_02A.FM
Subsection 02 (ADJUSTMENT AND REPAIR)
Materials
– fiberglass mat
– fiberglass cloth
– polyester resin
– cardboard
– masking tape
– sandpaper (100-grit, 220-grit, 320-grit, 400-grit,
600-grit, 1000-grit)
– 24-grit sanding disks
– Bombardier gelcoat putty
– Bombardier liquid gelcoat
– acetone
– cabosil
– epoxy filler
– medium compound (white)
– fine compound (white)
– wax
THRU-HULL FITTING
INSTALLATION
For hull insert repair proceed as follows:
Cut plastic hull insert flush with hull using a saw.
1. Hull
2. Plastic hull insert
www.SeaDooManuals.net
Section 12 HULL/BODY
12-02-19