Sea-doo RX Shop Manual page 47

Section 02 MAINTENANCE
Subsection 05 (STORAGE)
Disconnect water INLET hose where shown.
1. Disconnect hose this side of T-fitting
Antifreeze
Insert a funnel into hose and pour antifreeze mix
in engine until the colored solution appears at cool-
ing system bleed outlet (LH side of hull).
At this point, remove the hose pincher at tuned
pipe bleed hose. If necessary, continue to pour an-
tifreeze mix until the colored solution appears at
the other cooling system bleed outlet (stern eye-
let).
Remove the remaining hose pinchers in this order
to allow proper flow of antifreeze.
1. Engine cylinder drain hose.
2. Water outlet hose.
Pour approximately 200 mL (7 oz) of antifreeze in
the water regulator valve supply hose to allow an-
tifreeze flowing through the valve and into muffler
to protect it.
Reconnect hose to T-fitting.
02-05-4
DI Models
Install hose pinchers at the following location:
1. Water outlet hose
1. Crankcase cooling cover outlet hose
1. Engine cylinder drain hose
www.SeaDooManuals.net
SMR2000-041_02_05A.FM