Sea-doo RX Shop Manual page 273

Section 10 PROPULSION SYSTEM
Subsection 02 (JET PUMP)
Install impeller remover/installer tool into impeller
splines and tighten.
F00J08A
1. Impeller remover/installer tool
CAUTION: Make sure thrust washer and bearing
are not wedged in shaft groove. To check, man-
ually pull and push jet pump housing, some axial
play must be felt.
Torque impeller to 110 N•m (81 lbf•ft) then remove
tools.
CAUTION: Never use any impact wrench to tight-
en impeller.
Apply synthetic grease (P/N 293 550 010) on im-
peller splines.
Insert a new boot no. 13 and ring no. 14 to impeller.
1
F00J0IA
1. Boot and ring
10-02-16
1
Anti-Rattle System
Install spring no. 27 on slider no. 26.
1. Spring
2. Slider
Insert slider and spring into cover.
NOTE: Align the longer slider tab with hole.
Apply synthetic grease on the stem of pusher
no. 25.
Install pusher into cover. Place the flat side in front
of slider tab.
www.SeaDooManuals.net
SMR2000_065_10_02A.FM