Ip Rsvp Signalling Refresh Misses; Configuration); Mpls Traffic-Eng Ds-Te; Ip Rsvp Signalling Refresh Misses (Interface Configuration) - Zte ZXR10 8900 Series Command Reference Manual

Example
Command
Function
Command Modes
Command format
Parameter
Description
Default
Configuration
Tips
Example
Purpose
Command Mode
Syntax
Defaults
Instructions
will delete corresponding refresh message save state. By execut-
ing command no, default number configuration is reset.
To configure the number of lost refresh packets in MPLS traffic
engineering to 6, execute the following command:
ZXR10(config)#ip rsvp signaling refresh misses 6
ip rsvp signalling refresh
misses (Interface

Configuration)

This command is used to configure the number of lost refresh pack-
ets. When refresh packets of the specified number get lost, RSVP
will delete corresponding refresh message save state.
Interface configuration mode
ip rsvp signalling refresh misses <msg-count>
no ip rsvp signalling refresh misses
Parameter
<msg-count>
The default value is 4.
This command is used to configure the number of lost refresh pack-
ets. When refresh packets of the specified number get lost, RSVP
will delete corresponding refresh message save state. By execut-
ing command no, default number configuration is reset.
To configure the number of lost refresh packets in MPLS traffic
engineering to 6, execute the following command:
ZXR10(config-if)#ip rsvp signaling refresh misses 6

mpls traffic-eng ds-te

Use this command to enable DSTE function at the global configu-
ration mode. Use the command no to clear the configuration.
Global Configuration Mode

mpls traffic-eng ds-te

no mpls traffic-eng ds-te
Disable DSTE function by default.
V4.8.20 and its later versions support this command.
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 5 MPLS Traffic Engineering Configuration
Description
This is the number of lost refresh packets, in
range of 4-10.
89