Parameter
<iif-name>
<oif-index>
For a description of the parameters in Step 4, refer to the following table:
Parameter
<index>
<interface-name>
15.3 Maintaining IPv6 Static Multicast
To maintain IPv6 static multicast routing, run the following commands:
Command
show ipv6 multicast-static-interface[index
ZXR10#
<index>]
show ipv6 multicast-static-route [group <g
ZXR10#
roup-address>|[source <source-address>]]|[source
<source-address>]
#show ipv6 multicast-static-route summary
ZXR10#
15.4 IPv6 Static Multicast Configuration Example
l
Configuration Description
Figure 15-1
multicast route (source address: 1::, destination address: ff88::1) to forward multicast
packets.
Figure 15-1 Sample Networking Topology for the IPv6 Static Multicast
Configuration
l
Configuration Flow
SJ-20150114102049-011|2015-01-15 (R1.0)
shows a sample networking topology. It is required to configure a static
15-3
Chapter 15 IPv6 Static Multicast Configuration
Description
Name of the ingress interface for the multicast
route.
Sequence number of the egress interface for the
multicast route.
Description
Sequence number of the egress interface.
Name of the egress interface.
Function
Displays valid interfaces in the egress interface
set.
Displays the contents in the static multicast
routing table.
Displays the statistics on the contents in the static
multicast routing table.
ZTE Proprietary and Confidential