Ordering Paper And Supplies; Ordering Thermal Receipt Paper; Ordering Forms - NCR 7156 Owner's Manual

Chapter 1: About the 7156 Printer

Ordering Paper and Supplies

Thermal receipt paper, ribbon cassettes, and forms can be ordered. Documentation is also
available.

Ordering Thermal Receipt Paper

The 7156 requires "fax grade" thermal paper with the following dimensions:
Diameter
80 mm max. (3.15 in.)
The paper must not be attached at the core. Otherwise the receipt station will be damaged
when the paper is exhausted.
The paper low LED will blink when there are about 4 ½ meters (15 feet) of paper left. If the
paper runs out, the paper low LED stays on and the printer stops printing.
The host computer will alert you that the paper in the receipt station is out (depending on
the application program running on the host computer).
To order thermal receipt paper, contact your sales representative or order from NCR at the
following address or toll free number:

Ordering Forms

The 7156 prints on single- or multiple-part forms in the slip station (up to five-part forms).
Forms and slips must meet the following requirements:
To order forms, contact your sales representative or order from NCR at the following
address or toll free number:
4
Length
83 meters (273 ft.)
NCR
Media Products Division
9995 Washington Church Road
Miamisburg, OH 45342
Voice: 1(800)543-8130 (toll free), or local listing of Media Products sales office
Front insertion (minimum):
51 mm (2.0 inches) wide
70 mm (2.75 inches) long
Side insertion (minimum):
203 mm (8.0 inches) wide
51 mm (2.0 inches) long
Single-ply forms should be on paper that is greater than 15 pounds
Multiple-part forms (up to five parts) should be no thicker than .406 mm
(.016 inches)
NCR
Media Products Division
9995 Washington Church Road
Miamisburg, OH 45342
Voice: 1(800)543-8130 (toll free), or local listing of Media Products sales office
Width
80 mm ± .5 mm (3.15 ± .008 in.)
September 1997
7156 Owner's Guide