Rep 10.1 Offset Catch Tray (Oct); Rep 10.2 Exit Tray Extension - Xerox N2125N - DocuPrint B/W Laser Printer Service Manual

REP 10.1 Offset Catch Tray (OCT)

Parts List on PL 14.1
Removal
WARNING
Switch off the power and disconnect the Power Cord.
1. Open the printer Rear Cover.
2. Press the two locking tabs at the rear of the Offset Catch Tray
3. Lift the rear of the Offset Catch Tray approximately 1 inch (25mm).
4. Slide the Offset Catch Tray toward the rear and remove
Figure 1 Offset Catch Tray
Replacement
1. Reinstall the components in the reverse order.
Initial Issue
DocuPrint N2125

REP 10.2 Exit Tray Extension

Parts List on
Removal
Switch off the power and disconnect the Power Cord.
1.
(Figure 1). 2.
3.
(Figure 1). 4.
Replacement
1.
02/2000
4-67
manuals4you.com manuals4you.com
PL 14.1
WARNING
Open the Exit Tray Extension.
Slide the tray to the left.
Carefully deflect the center of the tray until the right hinge pin is free
Slide the tray to the right and remove (Figure
Figure 1 Exit Tray Extension
Reinstall the components in the reverse order.
(Figure 1).
1).
Repair-Adjustment
REP 10.1, REP 10.2