Waste Toner Bottle Full Sensor - Printronix L5035 Maintenance Manual

Chapter 10
Replacement Procedures
3. Remove the waste toner bottle from the waste toner recovery unit.
4. Discard the old waste toner bottle.
5. Install a new waste toner bottle.

Waste toner bottle full sensor

1. Remove the waste toner bottle (page 411).
2. Disconnect the three connectors, as shown below.
Connectors (3)
3. Remove the screws (1 each) securing the two brackets protecting the
light emitters and receptors.
4. Remove the screws (1 each) securing the Sensor-A and Sensor-B PC
boards, and remove the receptors.
412
Sensor-B
PC Board
Sensor-A
PC Board
Screws (4)