Table of Contents
Advertisement
Basic Operation
Basic Operation
After initializing (due to turning on the power or receiving an initialization
request from the printer), the power stacker enters into the following main
loop and repeatedly executes the various subroutines. However, the actuator
driving subroutines are selectively executed only upon the power stacker
receiving execution commands from the printer. The timing for driving the
various actuators is determined by the page last raster signal (LSCA) from the
printer, based on the paper head and tail status setting.
Status confirmation processing
Communication processing
Driving the stacker
Driving the elevator motor
Driving the swinger motor
Driving the assisting
arm drive motor
Switch monitoring
683
Advertisement
Chapters
Table of Contents
