Printronix L5035 Maintenance Manual page 65

5. Working from the underneath side of the transport assembly, loosen the 2
fan plenum screws marked "loosen" in the previous figure. Remove the
other 2 fan plenum screws (marked "remove" in the figure).
6. Disconnect the fan cable connector, then remove the fan and plenum
together from the transport assembly.
7. Working from the underneath side of the transport assembly, remove the
EPS4 mounting screws (2).
8. Disconnect the EPS4 sensor assembly cable connector (not shown), then
remove the sensor assembly from the transport assembly.
TC Connector block of the transfer / separator charger
The TC connector block of the transfer/separator charger is attached to the
unit frame on the rear side of the transport unit. When replacing this connector
block, replace the terminal block that is connected by cable at the same time.
1. Remove the transfer assembly (page 434).
2. Remove the screw (1) securing the connector block to the bracket.
TC connector block
3. Remove the screw (1) securing the terminal block to the unit frame, and
remove the connector and terminal block together.
Screw
Inside the Front Cover
443