Table of Contents
Advertisement
Cooling Fan
1. Turn off the printer.
2. Disconnect the printer AC power cable from the power source.
3. Remove the printer left rear cover (page 401).
4. Remove the controller module side cover. (See the illustration on the
following page.)
5. Disconnect the fan power cable connector and remove the cable tie wrap
(not shown).
6. Remove the screws and washers (2 each) securing the fan.
7. Lift the cooling fan out of the controller module.
8. To install the fan, reverse the above steps.
Floppy disk drives
(Ref.)
(Not used on flash
memory equipped
printers)
Controller module
Fan
Side cover
Controller Module
523
Advertisement
Chapters
Table of Contents
