Printronix L5035 Maintenance Manual page 48

Chapter 10
Replacement Procedures
Separator claw assembly
1. Remove the rear cover and the top cover.
2. Check that the transfer charger is in the down position, then lower the
transport unit by turning the green lever on the transport unit to the left
(see steps 9 and 10 on page 418).
3. At the rear side of the printer, disconnect the connector, as shown below.
4. Remove the screws (2), as shown below.
5. At the front side of the printer, remove the screws (2) securing the
separator claw assembly, then remove the assembly from the front.
Screws (2)
426
Connector
Screws