Table of Contents
Advertisement
Chapter
10
Replacement Procedures
Cutter Unit
CAUTION
Bearings can fall out of the pulley when removing it. Also, the pulley
must be put on the same way it was removed. This pulley is actually
made up of three separate pulleys that are molded into one piece. The
middle pulley is much larger than the two outside ones. Although the
two outside pulleys appear to be the same size, they are not. If the
outside pulleys are reversed, a jam results.
IMPORTANT
In order to avoid putting pulleys on backwards, mark their outside
edges with white.
1. If necessary, remove the rear belts by lifting the tension roller (it may not
be necessary to remove the belts for screw removal).
484
Advertisement
Chapters
Table of Contents
