Printronix L5035 Maintenance Manual page 328

Appendix D
Optional Power Paper Stacker
6. Remove the screws (4) securing the belt clamp plates (2 sets), then
remove the two sets of belt clamp plates from around the belts, as shown
below.
Tension adjustment nuts (4)
Screws (4),
in step 8
Elevator top channel
7. Remove the tension adjustment nuts (4), the tension adjustment brackets
(2), and the springs (2). Then remove the two elevator upper pulley
assemblies with attached belts from the elevator top channel, as shown
above.
8. Remove the screws (4) securing the elevator top channel to the stacker
base assembly, then remove the elevator top channel, as shown above.
CAUTION
Be careful not to damage the wiring during removal or replacement.
9. Remove the elevator carriage assembly and the two elevator upper pulley
assemblies with attached belts by pulling them upward from the stacker
base assembly, as shown above.
706
Springs (2)
Tension
adjustment
brackets (2)
Stacker
elevator
belts (2)
Elevator
carriage
assembly
Stacker base assembly
Elevator upper
pulley
assemblies (2)
Screws (4),
in step 6
Belt clamp plates (2 sets)