Printronix L5035 Maintenance Manual page 61

NOTE: When replacing a transport belt, be careful to distinguish the outer
surface of the new belt from its inner surface, as shown below. The
outer surface looks like graph paper, while the inner surface has an
irregular pattern. Adjust the distance between the drive shafts
according to the length of the belt.
Outer surface of belt
13. To adjust the belt tension, refer to the figure below and loosen the screws
(2 right, 2 left) securing the belt shaft to the conveyer base, then adjust
the tension of the belts by turning the set screws with a hex wrench.
A
Set screw
A
Inside the Front Cover
Inner surface of belt
Conveyer base
Screws
A
439