Printronix L5035 Maintenance Manual page 58

Chapter 10
Replacement Procedures
underneath it to protect the protruding tips of the sensor levers. Also, be
careful when handling the green lever.
1. Referring to the figure below, remove the vacuum fan and disconnect its
connector.
Connector
Transfer assembly
2. Disconnect the cables from the three (3) cable clamps.
3. Restore the transfer assembly to its original, right-side up position.
4. Referring to the figure below, remove the screws (2 on the front, 2 on the
rear) securing the output guide, then remove the output guide.
Screw
Output guide
436
Screw
Vacuum fan
Green lever
Transfer
assembly