Printronix L5035 Maintenance Manual page 74

Chapter 10
Replacement Procedures
3. Remove the E-ring and the tab washer from the motor shaft, as shown in
the figure below.
Connectors (2)
4. Loosen the setscrew using the hex wrench, then remove the flywheel.
5. Remove the screws (4) that hold the drum motor to the printer base, then
remove the drum motor from the paper feed area.
6. Disconnect the connectors (2) and remove the drum motor.
452
Screws (4)
Flywheel
Tab washer
Set screw
E-ring