Proper Disposal Of A Drum Unit; Drum Peripheral Equipment - Printronix L5035 Maintenance Manual

Chapter 10
Replacement Procedures
27. Raise the transport unit by reversing Step 10.
28. Reinstall the upper inner cover and tighten the thumbscrews.
29. Close the waste toner recovery unit and ensure that it latches.
30. Close the printer front cover.

Proper Disposal of a Drum Unit

Due to the nature of the material used in drum manufacturing, federal
regulations prohibit inappropriate disposal of laser print drums. Dispose of
used drums by shipping them to one of the following:
Within U.S.A.
Outside U.S.A.

Drum Peripheral Equipment

The equipment listed below is located around the photoreceptor drum.
Note that the main charger, precharger, transfer charger, and the discharge
lamp can be removed without removing the drum plate.
•
Main charger (MCH)
•
Precharger (PCH)
•
Transfer / separator charger (TCH / SCH)
•
Discharge lamp (PEL)
•
Drum cleaning unit
•
Separator claw unit
•
Drum support roller
•
LED print head* (see page 478)
•
Drum surface potential sensor unit (DSPS)* (see page 487)
*Items followed by an asterisk (*) are removed from under the top cover.
422
U.S. Fuji Electric, Inc.
240 Circle Drive
Piscataway, NJ 08854
Attn: Rod Storm
Phone: (908) 560-9410
Fuji Electric GmbH
Mr. Takeshi Kusaba, President (Mr. Kazumasa Ozawa, Manager)
Lyoner Str. 26
D-60528 Frankfurt am Main,
Germany
TEL: (069) 669-0290
FAX: (069) 666-1020