Printronix L5035 Maintenance Manual page 60

Chapter 10
Replacement Procedures
10. Referring to the figure below, remove the inner E-rings (2) securing the
drive shaft to the conveyer base.
Inner bearing
Inner e-ring
11. Referring to the figure above, slip the inner drive shaft bearings (2) out of
their holes in the conveyer base, then slide them toward the outer ends of
the drive shaft.
12. Remove the drive shaft from the conveyer base, then remove the three
(3) transport belts, as shown below.
Transport belt (3)
438
Inner e-ring
Conveyer base
Inner bearing
Drive shaft