Paper Near-End Sensor (Pnes) - Printronix L5035 Maintenance Manual

Chapter 10
Replacement Procedures
Sensor
Connector
Screws (2)
Sensor bracket
Screws (2)

Paper Near-End Sensor (PNES)

Photoemitting board
1. Remove the screws (4) securing the photoemitting board cover, then
remove the cover.
2. Remove the screw (1) securing the photoemitting board bracket to the
paper near-end sensor assembly.
3. Remove the screw (1) securing the photoemitting board to the
photoemitting board bracket.
4. Disconnect the connector from the photoemitting board.
512