Printronix L5035 Maintenance Manual page 59

5. Referring to the figure below, remove the screw (1) and nut (1) securing
the stainless plate, then remove the stainless plate.
Outer bearing
Outer e-ring
Stainless
plate
Outer e-ring
Red
high-voltage
wire
Unit frame
6. Referring to the figure above, remove the outer E-rings (2) securing the
drive shaft to the unit frame.
7. Referring to the figure above, slip the outer drive shaft bearings (2) out of
their holes in the unit frame, then slide them toward the outer ends of the
drive shaft.
8. Referring to the figure above, remove the screw (1) fastening the red
high-voltage wire to the conveyer base.
9. Referring to the figure above, remove the conveyer base from the unit
frame.
Inside the Front Cover
Conveyer base
Drive shaft
Outer bearing
437