Chapter
10
Replacement Procedures
6. At the rear side of the printer, disconnect connectors J11 and TRG from
Connector J11
(to MC board)
AC line
terminal strip
Ground wire
(FG wire)
Screw
AC lines
7. Open the cover of the AC line terminal strip on the flash power supply,
8. Remove the screw securing the ground wire (FG wire) to the printer
496
the flash power supply.
Rear side of printer
and disconnect AC lines "L" (black) and "N" (white).
frame.
Connector TRG
(trigger, to lamp
trigger coil)