Printronix L5035 Maintenance Manual page 77

Feed motor (FMT) / Encoders (FME19/20)
In the feed motor block, encoders 19 and 20, along with the motor itself (with
bracket), are replacement parts, and are removed as follows:
1. Referring to the figure below, mark the sensor connectors (2) for
identification so that you can connect them properly when you reinstall
the motors.
2. Disconnect the sensor connectors (2).
3. Remove the sensor wires from the cable clamps (2).
Motor
bracket
4. Mark the motor power connectors (2) for identification.
5. Disconnect the motor power connectors (2).
6. Remove the motor power wires from the harness clamps (2) located
under the motor bracket.
7. Remove the harness clamps (2) from the motor bracket.
Power
connectors
(2)
Harness
clamps
Sensor bracket
(2)
Inside the Rear Cover
Cable
clamps
(2)
Sensor
connectors (2)
Sensor
455