Table of Contents
Advertisement
3. If you are replacing the tractor motor, do steps a through d below.
Otherwise, skip to step 4.
a. Remove the motor cover, then disconnect the tractor motor
connectors (2).
Connectors
b. Remove the screws (4) fastening the tractor motor to the printer base.
c. Remove the tractor motor by pulling it through an opening in the
paper feed guide.
d. Install the new tractor motor by reversing steps a through c above.
4. Reinstall belts A and B, making sure that the motor pulley and pulleys C
and S are in alignment, as shown below.
Inside the Rear Cover
Screws
Alignment
marks
461
Advertisement
Chapters
Table of Contents
