Cutter Unit - Printronix L5535 Maintenance Manual

Hide thumbs Also See for L5535:

Table of Contents

Under The Top Cover

Cutter Unit

Bearings can fall out of the pulley when you remove it. Also, the pulley

must be put on the same way it was removed. This pulley is actually

made up of three separate pulleys that are molded into one piece. The

middle pulley is much larger than the two outside ones. Although the

two outside pulleys appear to be the same size, they are not. If the

outside pulleys are reversed, a jam results.

1. In order to avoid putting pulleys on backwards, mark their outside edges.

2. Remove the two rear belts by lifting the tension roller.

Tension Roller

Rear Belts (2)