Attaching The Front Bezel To The Chassis; Removing The Server From The Rack - Silicon Graphics 1450 Mounting Instructions

Attaching the Front Bezel to the Chassis

Removing the Server from the Rack

007-4242-001
4. If you want to secure the handle to the rack, place screws in the top and bottom
holes on the outside edge of the handle. Tighten both screws.
The front bezel attaches to and protects the front of the server.
1. Make sure that you pull the chassis out of the rack until the safety latch snaps into
place.
2. Place the front bezel over the front of the chassis. The edge of the bezel should align
with the front edges of the chassis. The ball studs on the back of the bezel fit easily
into holes on the front of the server.
3. Gently push the front bezel into the chassis. The front bezel snaps into place.
To remove the server from the rack, follow these steps:
1. Pull the server out until the safety latches on each side lock into place.
2. Make sure that a hand-truck or other mechanical assist unit is placed directly under
the server.
3. Depress the safety latches on both sides and simultaneously pull the chassis out of
the slide assembly.
4. Pull out the hand-truck or other mechanical assist unit along with the chassis.
Attaching the Front Bezel to the Chassis
15