Using The Ls/Gs Card For Ground-Start; Installing The Api Card For Panavoice - Panasonic DBS-576 Technical Manual

Section 400-Programming
Before Removing a Trunk or Extension Card from a Free Slot
Introduction
First clear the Trunk Numbers or Extension Numbers assigned to the ports on the card in programming.
This is for system "housecleaning" purposes, so the numbers can be automatically removed from other
areas in programming such as Hunt Groups, etc.
0
Addresses for Trunk Cards:
System
Configuration
Trunk Numbers for analog CO trunks:
(LTRK/8, LGTRK8, DIDTR8)
Trunk Numbers for analog E&M tie trunks:
(E&M/4)
FF1
Trunk Numbers for ISDN trunks:
System
(TBRI/4, PRI/8, PRI/16, PRI/23)
Trunk Numbers for T1 trunks:
(T1/8, T1/16, T1/24)
FF2
Addresses for Extension Cards:
Trunks
Extension Numbers for digital or SLT phones:
(DEC/8, AEC/8)
Extension Numbers for ISDN extensions:
(SBRI/4, PRI/8, PRI/23)
FF3
Extensions

Using the LS/GS Card for Ground-Start

FF4
In order to use the Loop-Start/Ground-Start Trunk Card (LGTRK8) for ground-start signaling:
FF-/Soft Keys
A pair of jumpers for each circuit must be installed on the card.
A -48V power supply must be installed in the cabinet.
Ground lead on power supply must be installed properly ("SG" connected to Ground screw).
FF5
See Section 300-Installation for more information.
Groups
FF6

Installing the API Card for PanaVOICE

TRS/ARS
The API Card is required if PanaVOICE (proprietary Voice Mail) is installed. When configuring the
Free Slot for the API Card, use Card Type address numbers 80-87 (see table, pg. 0-7).
FF7
Not more than one API Card can be installed per cabinet.
Applications
The API Card can be installed in any Free Slot between 01 and 11.
A DEC or AEC Card, which can provide up to 8 voice ports, must also be installed in the Free Slot
immediately after (to the right of) the API Card.
FF8
If the API Card doesn't use all 8 ports on the DEC or AEC for voice mail, the remaining ports can be
Maintenance used for normal extensions.
The API Card will always choose Port #8 (last port) on the DEC or AEC as the 1st voice port. The 2nd
voice port is always Port #7 on the DEC/AEC; the 3rd voice port #6; etc. See illustration (next page).
Appendix A
Appendix B
576-13-400
FF2 0 BSSC 00 Hold (0-576) Hold (pg. 2-7)
FF2 0 BSSC 00 Hold (0-576) Hold (pg. 2-37)
FF2 1 BSSC 01 Hold (0-576) Hold (pg. 2-60)
FF2 2 BSSCC 01 Hold (0-576) Hold (pg. 2-87) --CO
FF2 2 BSSCC 01 Hold (0-576) Hold (pg. 2-116) --E&M
FF3 0 BSSC 02 Hold (0-9999) Hold (pg. 3-4)
FF3 1 BSSC 01 Hold (0-9999) Hold (pg. 3-29)
DBS 576 (USA) issued 05/20/98
0: System Configuration
Page 0-3
Introduction
0
System
Configuration
FF1
System
FF2
Trunks
FF3
Extensions
FF4
FF-/Soft Keys
FF5
Groups
FF6
TRS/ARS
FF7
Applications
FF8
Maintenance
Appendix A
Appendix B