Panasonic DBS-576 Technical Manual page 178

Section 400 programming

Hide thumbs Also See for DBS-576:

Table of Contents

FF1: System Programming

Introduction

Flash Timer 2 for Trunk Line

(all CPCs) - Version 1.0 or higher

Set the length of time a flash signal to a trunk line will last when the extension user

depresses FL/R key (U.K./Hong Kong) or FLASH or PROG key (U.S.). Applies when

Configuration

Flash Pattern #2 is programmed for the trunk. Also applies when DBS 576 system is

behind a PBX, and the user needs to send a Recall signal to the PBX to place the call on

hold at the PBX.

When the phone does not have a FLASH or FL/R key, the end-user must press the FF-key programmed

FF-/Soft Keys

with the Flash/Recall code (*39 by default) to send the Recall signal.

Related Programming:

Flash Pattern ...

for analog CO trunks (pg. 2-18)

for analog E&M tie-trunks (pg. 2-46)

for T1-CO trunks (pg. 2-97)

for T1-E&M tie-trunks (pg. 2-126)

Applications

FF1 1 01 0002 Hold (1-255) Hold

FF2 0 BSSC 02 01 Hold (0 or 1) Hold

FF2 2 BSSCC 03 01 Hold (0 or 1) Hold

DBS 576 (USA) issued 05/20/98

1 = (1 x 16 ms) = 16 ms

2 = (2 x 16 ms) = 32 ms

3 = (3 x 16 ms) = 48 ms

124 = (124 x 16 ms) = 1,984 ms or 1.984 seconds

125 thru 255 = same value (2.5 seconds)

default: 5 (80 ms)

Section 400-Programming

Introduction

Configuration

FF-/Soft Keys

Applications