Ff1 1 02: Trunk Timer 2 - Panasonic DBS-576 Technical Manual

Section 400-Programming
Introduction

FF1 1 02: Trunk Timer 2

0
System
Configuration
DISA No-Answer Timer #1
(all CPCs) - Version 1.0 or higher
Set how long the system will wait before changing an unanswered DISA call
FF1
to multiple-incoming ringing.
System
FF2
Trunks
FF3
Extensions
Notes:
FF4
FF-/Soft Keys
This address does not affect DID calls, which (if unanswered) will continue to ring an idle extension
indefinitely, or until the user performs another action on the phone (such as accessing another trunk for
an outgoing call) while the DID call is ringing. At that point, the DID call will change to multiple-
incoming ringing. NOTE: The user will not be able to perform another action on the phone if the
FF5
extension's Trunk Key Operation: Direct Calls (pg. 3-14) setting is left at "1=Ignore key press
Groups
(default)," in which case the DID call will continue to ring the extension.
Multiple-Incoming Ringing: An incoming trunk call will ring on all extensions that have a line
appearance (FF-key) for that trunk. The trunk's Ring Type must be set to "0=Multiple Incoming
FF6
(default)" in FF2. Trunks are assigned to FF-keys in FF4.
TRS/ARS
DID (Direct Inward Dial): An outside caller can reach an internal extension directly by dialing a 7-
digit CO phone number. The DID trunk passes the last 2 to 4 digits of the phone number to the PBX,
and the digits become (or are modified to become) the equivalent of an extension number. DID trunks
FF7
can't be used for outgoing calls (no dialtone offered). To set up DID, set the Analog-CO, ISDN, or T1-
Applications
CO trunks for DID in the Ring Type addresses (FF2). Enter the DID numbers and assign their ring and
delayed-ring destinations in FF1 4: DID/DNIS Tables (see pg. 1-168).
DISA (Direct Inward System Access): By dialing the DISA trunk's CO phone number, an outside
FF8
caller can dial into the phone system, and have full access to all the system's features without going
Maintenance
through the Attendant (including the ability to transfer himself to different extensions, or dial-out on
another trunk). To set up DISA, set the Analog-CO, ISDN, or T1-CO trunks for DISA service in the
Ring Type addresses (FF2). Create DISA ID Codes and assign TRS Classes to them in FF1 0 26:
DISA ID Codes (see pg. 1-113).
Appendix A
Related Programming:
DISA No-Answer Timeout (pg. 1-31)
Appendix B
576-13-400
FF1 1 02 0001 Hold (0-255) Hold
(setting=no. of seconds):
FF1 0 02 0017 Hold (0 or 1) Hold
DBS 576 (USA) issued 05/20/98
FF1: System Programming
/ ) /)
0 = 5 seconds
1 = 1 second
2 = 2 seconds
...
255 = 255 seconds
default: 30 seconds
Introduction
0
System
Configuration
FF1
System
FF2
Trunks
FF3
Extensions
FF4
FF-/Soft Keys
FF5
Groups
FF6
TRS/ARS
FF7
Applications
FF8
Maintenance
Appendix A
Appendix B
Page 1-127