Ff2 0: Analog Trunks (Co) - Panasonic DBS-576 Technical Manual

Section 400-Programming
Introduction

FF2 0: Analog Trunks (CO)

NOTE:
0
System
Configuration
FF1
Trunk Number Assignment
System
(all CPCs) - Version 1.0 or higher
Assign trunk numbers to analog CO trunk circuits. (Maximum 576 trunk
circuits are available in a 6-cabinet system with a CPC-576 card.)
FF2
Trunks
FF3
BSSC: Analog (CO) Trunk Position
Extensions
FF4
FF-/Soft Keys
Notes:
Press the BLK-DOWN soft key instead of the last HOLD in the above address, to scroll to the next
BSSC trunk position and assign it a trunk number (stay in same address).
FF5
Before removing a Trunk Card from a Free Slot, you must first clear the Trunk Numbers (if assigned)
Groups
from all of the Card's BSSC ports in this address. See pg. 0-3 for more information.
The range of trunk numbers available for assignment depends on the CPC used:
FF6
with a CPC-96:
TRS/ARS
with a CPC-288:
with a CPC-576:
FF7
Related Programming:
Applications
Trunk Connection Type (CO/PBX) (pg. 2-19)
Trunk Numbering (pg. 1-22)
FF8
Maintenance
Appendix A
Appendix B
576-13-400
The same FF2 0 addresses are also used for analog E&M tie trunks.
However, their settings are different. See page 2-37 for Analog Trunks
(E&M Tie) settings.
FF2 0 BSSC 00 Hold (0-576) Hold
B=Cabinet no. 1-6
SS=Slot no. 01-12
C=Circuit no. 1-8
Trunk Nos. 1-96
Trunk Nos. 1-288
Trunk Nos. 1-576
FF1 0 02 0001 Hold (0 or 1) Hold
DBS 576 (USA) issued 05/20/98
FF2: Trunk Programming (Analog CO)


Trunk Number assigned to trunk circuit
(0 = no trunk)
default: [no assignment]
FF2 0 BSSC 02 04 Hold (0 or 1) Hold
$
%-4 )-8
(or BLK-DOWN)
Page 2-7
Introduction
0
System
Configuration
FF1
System
FF2
Trunks
FF3
Extensions
FF4
FF-/Soft Keys
FF5
Groups
FF6
TRS/ARS
FF7
Applications
FF8
Maintenance
Appendix A
Appendix B