Panasonic DBS-576 Technical Manual page 376

FF2: Trunk Programming (T1 E&M Tie)
Notes:
Introduction
Set this address to "1" (One-Way Link) to prevent double-dialing -- making an outgoing call on the
same trunk after the called party hangs up, thus bypassing TRS restrictions.
0 Related Programming:
System
Configuration
FF1
CO Dial Tone Simulation
System
(all CPCs) - Version 1.0 or higher
Set whether the system sends simulated CO dial tone to an extension using this
FF2 T1 channel (important for DID Wink-Start trunk signaling).
Trunks
FF3
Extensions BSSCC: T1 (E&M Tie) Channel Position
B=Cabinet no. 1-6
SS=Slot no. 01-12
CC=Channel no. 01-24
FF4
FF-/Soft Keys
Notes:
Set to "1" (Send) if the CO doesn't support dial tone (typical in U.K.).
FF5
Related Programming:
Groups
Trunk Signal Type (pg. 2-117)
FF6
TRS/ARS
SMDR for Outbound Calls
(all CPCs) - Version 1.0 or higher
Set whether outbound calls on the T1 channel will be included in SMDR records.
FF7
Applications
FF8
BSSCC: T1 (E&M Tie) Channel Position
Maintenance
B=Cabinet no. 1-6
SS=Slot no. 01-12
CC=Channel no. 01-24
Notes:
Appendix A
Appendix B
Page 2-128
FF2 2 BSSCC
FF2 2 BSSCC 02 00 Hold (0-5) Hold
FF2 2 BSSCC
DBS 576 (USA) issued 05/20/98
03 06 Hold (0 or 1) Hold
0=Do not send simulated CO dial tone
to extension. (default)
1=Send simulated CO dial tone to extension.
03 07 Hold (0 or 1) Hold
0=Do not include in SMDR.
1=Include in SMDR. (default)
Section 400-Programming
$ 
# %
$ %
2  #-6-0#-
576-13-400
Introduction
0
System
Configuration
FF1
System
FF2
Trunks
FF3
Extensions
FF4
FF-/Soft Keys
FF5
Groups
FF6
TRS/ARS
FF7
Applications
FF8
Maintenance
Appendix A
Appendix B